_________________________________________________________________________
EEC 210
Problem Set #3

1.  GHL&M 3.20 except replace both BJTs with n-channel MOS
    transistors and assume  W/L = 100, lambda = 0, and
    chi = 0.  Use Table 2.2 for other parameters.
    (The idea is this: add a 10k ohm resistor in series with the drain of M1,
     then use half circuits to analyze this balanced circuit.)

2.  Repeat problem 1 above with SPICE.

3.  GHL&M 3.26. (Problem should say 'Determine the worst-case offset ...')

4.  GHL&M 3.27.  Ignore the body effect. You can use the coupled half-circuits
    approach, or you can use the equations derived in lecture for the
    case considered here (i.e. only the load resistors are mismatched).
    Compare your answers with SPICE.

5.  GHL&M 4.3.
_________________________________________________________________________